Table of Contents
Advertisement
Installing and setting up PCU Base for IPC
10.3 Configuration of the system
Overview
You can make the following settings in the "Host Settings" dialog box:
Figure 10-4
Table 10-6
IP settings in the "Host Settings" dialog box
Settings
Network enabled
Firewall enabled
Use Windows Settings
DNS Configuration > Computer Name
DNS Configuration > Suffix Search List
10.3.14
Adapting the firewall settings
10.3.14.1
Overview
From a PG/PC in the plant network, you can directly access resources on the Siemens PC
system. The same applies when accessing a PG/PC from the Siemens PC system in the plant
network or in the company network.
If you want to access the Siemens PC system via the company network instead or in addition,
you must adapt the firewall settings.
202
Host settings
Purpose
Activate or deactivate the network interfaces of the PC system.
Activate or deactivate the firewall of the PC system.
Select whether the values set in the Control Panel are to be used.
Specify the DNS computer name.
Parameterize a search list for DNS suffix, e.g. "network.com".
The factory setting of the Ethernet interface "Local Area Connection"
is ".local".
Commissioning Manual, 02/2020, A5E47437618B AB
MCU commissioning: NC, PLC, Drive
Advertisement
Table of Contents
