Siemens SINUMERIK MC Commissioning Manual page 74

PLC commissioning
5.4 Creating a PLC program
Procedure
To copy program blocks of the basic program from a master copy to the program blocks folder
of the project tree, proceed as follows:
1. Switch to the "Libraries" task card and open the system library "SINUMERIK MC PLC Basic
Program V1.13.0.0", for example.
2. Drag the folder "Motion Control PLC BP" into the "Program blocks" folder, e.g. under
"MCU_1 > PLC_1 > Program blocks":
Note
Copying this folder changes the user-defined folder structure
Copying the "Motion Control PLC BP" folder automatically creates new groups (subfolders)
in your "Program blocks" folder and moves the existing blocks into them.
If you have already organized the basic PLC program into separate groups and would like
to keep this structure, copy the individual block copy templates from the lower-level folders
or select multiple block copy templates using multiple selection instead.
The blocks are copied to your project. A check is made for duplicate block names and, if
applicable, the "Conflicts when copying" dialog is displayed.
3. In the project tree, right-click "Program blocks" and in the "Compile" shortcut menu select
the command "Software (compile all)".
The PLC program is compiled and a check is made for duplicate block addresses, for
example.
74
MCU commissioning: NC, PLC, Drive
Commissioning Manual, 02/2020, A5E47437618B AB