SRX 5600 Services Gateway Getting Started Guide
Figure 9: Connecting AC Power to the Services Gateway
4.
Connect Power to a DC-Powered Services Gateway
WARNING: The device must be properly grounded before you connect the DC power
cables.
Table 3: DC Power System Input Voltage
16
Step 5: Connect Ground and Power Cables
Switch the AC switch on each power supply to the
the status LEDs on each power supply faceplate. If an AC power supply is correctly
installed and functioning normally, the
the
LED does not light.
PS FAIL
If any of the status LEDs indicates that the power supply is not functioning
normally, repeat the installation and cabling procedures.
Item
Specification
DC input voltage
Operating range: –40.5 to –72 VDC
position ( ) and observe
ON
AC OK
and
DC OK
LEDs light steadily, and