Connect Power To A Dc-Powered Services Gateway - Juniper SRX5400 Getting Started Manual

Figure 10: Connecting AC Power to the Services Gateway

Connect Power to a DC-Powered Services Gateway

This procedure addresses connecting power to services gateways equipped with DC power supplies.
WARNING:
to ensure proper operation, you must properly ground the services gateway chassis
before connecting power. See
instructions.
Table 3 on page 20 describes the services gateway input voltage requirements.
Table 3: DC Power System Input Voltage
Item
DC input voltage
To meet safety and electromagnetic interference (EMI) requirements and
"Step 4: Connect the Grounding Cable" on page 14
Specification
Operating range: –40.5 to –72 VDC
20
for