Connect Power To A Dc-Powered Services Gateway - Juniper SRX5600 Getting Started Manual

Services gateway

Hide thumbs Also See for SRX5600:

Table of Contents

Connect Power to a DC-Powered Services Gateway

NOTE:

Each power supply must be connected to a dedicated AC power

feed and a dedicated customer site circuit breaker. We recommend

using a 15-A (250-VAC), circuit breaker minimum, or as permitted by

local code.

Dress the power cord appropriately. Verify that the power cord does not block the

air exhaust or access to services gateway components, and that it does not drape

where people could trip over it.

Figure 10: Connecting AC Power to the Services Gateway

This procedure addresses connecting power to services gateways equipped with either

standard-capacity or high-capacity DC power supplies.

WARNING:

To meet safety and electromagnetic interference (EMI)

requirements and to ensure proper operation, you must properly ground the

services gateway chassis before connecting power. See

the Grounding Cable" on page 13

NOTE:

The services gateway must be running Junos OS Release 12.1X44-D10

or later in order to use high-capacity AC or DC power supplies.

Table 3 on page 18

describes the services gateway input voltage requirements.

Connect Power to a DC-Powered Services Gateway

"Step 4: Connect

for instructions.

Table of Contents