Creating A New Vt1.5 Mapping; Figure 178. Sts1 Mapping Action Menu - ADTRAN OPTI-6100 Installation Manual

OPTI-6100 Installation and Turn-Up Practice
Since Ethernet ports can contain a variable number of STS-1s, a
provided at the end. To create a new connection, highlight this option and press
Ethernet ports can be in either STS-1 or VT1.5 mode. In order to work with an Ethernet port
with the STS-1 mapping menu the port must be set to STS-1 mode. As long as there are no
cross-connects on a port the port mode can be changed.
As shown in Figure
TID: PHX-JMR
Unacknowledged Alarms:

Creating a New VT1.5 Mapping

VT1.5 mapping is very similar to STS-1 mapping. Non-Ethernet cards gain a new STS-1 level
within the card level. When a VT1.5 command is given, a prompt for a repeat count occurs,
which can duplicate the command over several consecutive VT1.5s. Use a repeat count of one
for functionality like the STS-3c and STS-1 menus.
An OMM12 not equipped with a TUP chip cannot map VT1.5s to non-Ethernet tributary
modules, and cannot map VT1.5 hairpins.
346
178, below, a port set to VT1.5 offers the option to switch to STS-1.
OPTI-6100 System
STS1 Mapping Action
Create One-Way Mapping : <STS1/VT mismatch>
Create Two-Way Mapping : <STS1/VT mismatch>
Delete One-Way Mapping : <Item is not mapped>
Delete Two-Way Mapping : <Item is not mapped>
Delete Broadcast
6. Set Items to STS1
Set Items to VT1.5
'?' - System Help Screen

Figure 178. STS1 Mapping Action Menu

Chassis: 1
: <Item is not broadcasting>
:
: <Items are already VT1.5>
Selection:
line is
<New connection>
E
NTER
MM/DD/YY HH:MM
Slot: HS1
61184500L1-5L
.