Table 134. Omm312V Provisioning Options - ADTRAN OPTI-6100 Installation Manual

19. From the Provisioning menu, select
20. From the Mapping menu, select the STS-1 or STS-3 to map, and press
Refer to "Mapping Cross-Connects"
21. Press to return to the Provisioning menu.
E
SC
Table 134 lists the minimum factory defaults and values that are loaded after installation and
self-test for the OMM312V modules.
Provisioning Options
System Mode
Equipment Provisioned State
Facility Provisioned State
Clock Switch Mode
Clock Source
Clock Out
Clock Out Mode
Clock Output LBO
Clock Output Type
Clock Output Source
Clock Out Source Mapping
OC-N Transmit Sync Message
Receive Sync Message
Signal Degrade
Signal Fail
61184500L1-5L
Mapping
on page 337 for mapping instructions.

Table 134. OMM312V Provisioning Options

Settings
Terminal (default)
♦
IS
♦
IS
♦
Auto Switch PRI/SEC (default)
♦
PRI Only
♦
Refer to "OMM Module Clock Source Settings"
♦ Enable
♦ Dual Output from Chassis (default)
♦ Single Output from Chassis
–
0 133 ft. (default)
♦
–
134 266 ft.
♦
♦ DS1 SF (default)
♦ Receive Fiber (default)
Internal Clock
♦
Out PRI = PRI, Out SEC = SEC (default)
♦
♦ Out PRI & SEC = Clock Source
♦ Derive From Source (default)
♦ Enable (default)
♦ 10 E-5 (default)
10 E-6
♦
10 E-3 (default)
♦
OMM Module Installation and Turn-Up
, and press .
E
NTER
UPSR
♦
OOS-MA
♦
OOS-MA
♦
♦ Disable (default)
–
267 399 ft.
♦
–
400 533 ft.
♦
♦ DS1-ESF
♦ Disable
♦ 10 E-7
10 E-8
♦
10 E-4
♦
.
E
NTER
OOS-MA UAS (default)
♦
OOS-MA UAS (default)
♦
SEC Only
♦
on page 249.
–
534 655 ft.
♦
♦ Ext Clock In
Trib Module
♦
Out PRI & SEC = PRI
♦
♦ Out PRI & SEC = SEC
♦
♦ 10 E-9
10 E-5
♦
245