Table 151. Ethm8E/Ethm8Ef Provisioning Options - ADTRAN OPTI-6100 Installation Manual

11. To set the Facility service state, complete the following steps:
a. From a Port Provisioning menu, select
b. From the Facility Provisioning menu, select
Table 151 on page 297 lists the minimum factory defaults and values that are loaded after
installation and self-test for the ETHM8E/ETHM8EF modules.

Table 151. ETHM8E/ETHM8EF Provisioning Options

Provisioning Options
Equipment Provisioned State
AINS Time
AINS Timer
VLAN Mode
Protocol ID (Double Tag only)
Port Provisioning Options (VLAN Mode noted):
Pause Frame
Peak Rate
Committed Rate (Double Tag only)
VLAN Uplink Tag (Double Tag only)
VLAN Uplink (Double Tag only)
Translation #1–6, Untagged Translation
(Translation only)
Speed
Duplex
Crossover
Protocol
Pause Frames
Burst Size
Refer to "Appendix C, Advanced Ethernet Provisioning"
provisioning options.
61184500L1-5L
Facility Provisioning
, and press
IS
Settings
IS
♦
OOS-MA
♦
1 Minute to 96 Hours; 4:00 is the default
Enabled
♦
Transparent (default)
♦
♦ Translation
♦ 0×9100 (default)
0×8100
♦
Enabled (default)
♦
5 – 100000 or Full Rate; Full Rate is the default
0 – <remaining VCG bandwidth>; 0 is the default
1 – 4093; 1 is the default
1 – 8; 1 is the default
The only option is Inactive
♦ Auto Negotiate (default)
10 Mbps
♦
Full Duplex/Auto (default)
♦
♦ Half Duplex Only
♦ None/Auto (default)
♦ Forced
♦ GFP (default)
X.86
♦
Enabled (default)
♦
32 – 4194 kb; 64 is the default
for more details on various Ethernet
Tributary Module Installation and Turn-Up
, and press .
E
NTER
.
E
NTER
OOS-MA UAS (default)
♦
Disabled (default)
♦
Double Tag
♦
♦ Other
Disabled
♦
♦ 100 Mbps
♦ PPP
Disabled
♦
297