Table 129. Omm12 Provisioning Options - ADTRAN OPTI-6100 Installation Manual

OPTI-6100 Installation and Turn-Up Practice
23. Repeat these steps to set the payload type and to map an STS to each equipped mid-speed
group. Remember to map both HS1 and HS2.
24. Press to return to the Provisioning menu.
E
SC
Table 129 lists the minimum factory defaults and values that are loaded after installation and
self-test for the OMM12 modules.
Provisioning Options
Equipment Provisioned State
System Mode*
Facility Provisioned State
Clock Switch Mode
Clock Source
Clock Out
Clock Out Mode
Clock Output LBO
Clock Output Type
Clock Output Source
Clock Out Source Mapping
OC-N Transmit Sync Message
Receive Sync Message
Signal Degrade
Signal Fail
*= This option only applies to UPSR modules.
232

Table 129. OMM12 Provisioning Options

Settings
♦ IS
OOS-MA
♦
Terminal (default)
♦
♦ UPSR
♦ IS
♦ OOS-MA
Auto Switch PRI/SEC (default)
♦
PRI Only
♦
Refer to "OMM Module Clock Source Settings"
Enable
♦
♦ Disable (default)
♦ Dual Output from Chassis (default)
Single Output from Chassis
♦
–
0 133 ft. (default)
♦
–
134 266 ft.
♦
–
267 399 ft.
♦
♦ DS1 SF (default)
DS1-ESF
♦
Receive Fiber (default)
♦
♦ Internal Clock
♦ Out PRI = PRI, Out SEC = SEC (default)
Out PRI & SEC = Clock Source
♦
Derive From Source (default)
♦
Don't Use
♦
Enable (default)
♦
♦ Disable
♦ 10 E-5 (default)
10 E-6
♦
10 E-7
♦
10 E-3 (default)
♦
♦ 10 E-4
♦ OOS-MA UAS (default)
♦ OOS-MA UAS (default)
SEC Only
♦
on page 249.
–
400 533 ft.
♦
–
534 655 ft.
♦
Ext Clock In
♦
♦ Trib Module
♦ Out PRI & SEC = PRI
Out PRI & SEC = SEC
♦
♦ 10 E-8
10 E-9
♦
10 E-5
♦
61184500L1-5L