ADTRAN OPTI-6100 Installation Manual page 325

11. To set the Facility Provisioning service state, complete the following steps:
a. From a Port Provisioning menu, select
b. From the Facility Provisioning menu, select
12. To configure a VCG and provision it IS, complete the following procedure:
a. From the Provisioning menu select
b. From the VCG Provisioning menus, select the a VCG range, and then the specific VCG.
c. From the VCG # Provisioning menu, modify the VCG Protocol (GFP or X.86), Frame
Check Sequence (GFP mode only), and LCAS Provisioning.
d. From the VCG # Provisioning menu, select
e. From the Provisioned Service State menu, select
13. To add members to the LCAS group, complete the following steps:
a. From the VCG # Provisioning menu, select
b. From the VCG # LCAS Provisioning menu, select
c. From the LCAS menu, select
A confirmation prompt appears:
A loss of traffic will occur. Are you sure? {Y,N}:
d. Press , and press
Y
e. From the VCG # LCAS Provisioning menu, select
f. Press four times to return to the main Provisioning menu.
E
SC
14. To activate a Flow (to allow Ethernet packets between an Ethernet Port and a VCG),
complete the following procedure:
a. From the Provisioning menu, select
b. From the Flow Provisioning menu, select
c. Enter the Flow Number (1–1000) of the Flow to use, and press
d. From the Flow # Provisioning menu, select
e. From the Flow # Input Selection menu, select
f. From the Flow # Input Selection menu, select the Ethernet port (1–8) to be the input
point for the flow.
g. From the Flow # Provisioning menu, select
h. From the Flow # Uplink Selection menu, select
i. In the Enter VCG Number field, select the VCG port (1–191) to use as the uplink.
j. If a port-based Transparent flow is desired (all packets from an Ethernet port to/from the
VCG), complete
k. From the Flow # Provisioning menu, select
l. From the Flow # Upstream VLAN Mode menu, select
m. From the Flow # Provisioning menu, select
61184500L1-5L
VCG Provisioning
Enabled
.
E
NTER
step k and step l. Otherwise, skip to
, and press
Facility Provisioning
, and press
IS
, and press
Provisioned Service State
, and press
IS
, and press
LCAS
, and press
LCAS
, and press
.
E
NTER
Add All Members
, and press
Flow Provisioning
Enter a Flow Number
, and press
Flow Input
Ethernet Selection Menu
, and press
Flow Uplink
Enter VCG Number
step
Up VLAN Mode
Transparent
Prov Serv State
Tributary Module Installation and Turn-Up
.
E
NTER
.
E
NTER
.
E
NTER
, and press
.
E
NTER
.
E
NTER
.
E
NTER
, and press
E
.
E
NTER
, and press
E
NTER
.
E
NTER
.
E
NTER
, and press
.
E
NTER
, and press
E
m.
, and press
.
E
NTER
, and press
E
, and press
.
E
NTER
.
E
NTER
.
NTER
.
.
E
NTER
.
NTER
.
NTER
299