Ds1 Module Provisioning; Ds1M/Ds1M2 Provisioning - ADTRAN OPTI-6100 Installation Manual

OPTI-6100 Installation and Turn-Up Practice

DS1 Module Provisioning

Each DS1 module has its own Provisioning menu tree. The following sections highlight some of
the items in the DS1 module menu trees needed to provision a new module.
Topics in this section include:

"DS1M/DS1M2 Provisioning"

♦
"DS1VM Provisioning"
♦
"DS1VME Provisioning"
♦
"DS1VMT Provisioning"
♦
"DS1VM2 Provisioning"
♦
"Mapping on DS1 VT Modules"
♦
"DS1 Framing" on page 275
♦
DS1M/DS1M2 Provisioning
Use this Provisioning procedure to provision the following modules:
DS1M (P/N 1184513L1)
♦
DS1M2 (P/N 1184513L2)
♦
To provision a DS1M/DS1M2 module, complete the following steps:
1. From the OPTI-6100 Main menu, select
2. From the MS Modules menu, select the DS1 module to provision, and press
3. From the ADTRAN DS1M Line Card menu, select
4. From the Provisioning menu, select
5. From the Equipment Provisioned State menu, select
In Service.
6. From the Provisioning menu, select
7. From the DS3 Framing menu, select
8. From the Provisioning menu, select
9. From the Facility Provisioning menu, select
10. From the Facility Provisioned State menu, select
11. From the DS3 (Backplane) menu, select
12. From the Facility Provisioned State menu, select a DS1 facility to provision the service state
individually, or
Set Multiple
If Set Multiple is selected, specify DS1s to place IS by entering the numbers separated by
commas (e.g.,
1, 3, 9
13. From the next menu, select
14. If provisioning DS1 facilities individually, repeat
256
on page 256
on page 259
on page 262
on page 265
on page 268
on page 271
MS Modules
Equipment Provisioned State
DS3 Framing
C-BIT
Facility Provisioning
IS
to provision multiple circuits at one time, and press
), in a range (e.g.,
1–5
, and press
IS E
, and press
, and press
Provisioning
, and press
and press
IS
, and press
E
NTER
or , and press
M13 E
NTER
, and press
Facility Provisioned State
DS3 (backplane)
, and press .
E
NTER
), or both (e.g.,
1-5, 9
to place the selection IS.
NTER
step 12 and step 13
.
E
NTER
.
E
NTER
.
E
NTER
.
E
NTER
to place the module
E
NTER
.
.
.
E
NTER
, and press .
E
NTER
, and press .
E
NTER
E
NTER
), and press
E
NTER
for each DS1.
61184500L1-5L
.
.