Ds3Ec1M3 Provisioning - ADTRAN OPTI-6100 Installation Manual

OPTI-6100 Installation and Turn-Up Practice

DS3EC1M3 Provisioning

Use this Provisioning procedure to provision the DS3EC1M3 module (P/N 1184533L1).
To provision the DS3EC1M3 module, complete the following steps:
NOTE
DS3 is treated as a pass-through signal. Framing is not supported.
1. From the OPTI-6100 Main menu, select
2. From the MS Modules menu, select the DS3EC1M3 module to provision, and press
3. From the ADTRAN DS3 Line Card menu, select
4. From the Provisioning menu, select
5. From the Equipment Provisioned State menu, select
6. From the Provisioning menu, select
7. From the Facility # Provisioning menu, select
8. From the Provisioned State menu, select
9. Repeat step 6 through
10. From the Provisioning menu, select
NOTE
AINS prevents alarms from being reported on facilities that are not
yet receiving a valid signal. Refer to
11. From the AINS Timer menu, select
12. From the Provisioning menu, select
13. On the AINS Time screen, enter the number of hours and minutes, and press
14. From the Provisioning menu, select
15. From the Board Operating Mode menu, select
16. From the Provisioning menu, select
17. From the Line Build Out menu, select
280
MS Modules
Equipment Provisioned State
Facility # Provisioning
IS,
step 8 for each remaining facility.
AINS Timer
, and press
Enable
AINS Time
Board Operating Mode
Line Build Out
Short
, and press
E
, and press
Provisioning
, and press
and press
IS,
, and press
, and press
Provisioned State
and press to place the facility IS.
E
NTER
, and press .
E
NTER
"Auto In-Service" on page 332.
.
E
NTER
, and press .
E
NTER
, and press
or , and press
DS3 EC1
, and press
E
NTER
or , and press
Long E
.
NTER
.
E
NTER
.
E
NTER
.
E
NTER
.
E
NTER
.
E
NTER
E
NTER
.
E
NTER
.
E
NTER
.
.
NTER
61184500L1-5L
.
E
NTER
.