NOTICE
Electrostatic discharge (ESD) can damage electronic modules.
♦
Before handling modules, wear an antistatic discharge wrist strap
to prevent damage to electronic components. Place modules in
antistatic packing material when transporting or storing. When
working on modules, always place them on an approved antistatic
mat that is electrically grounded.
Inspect all modules prior to installation. If a module has been
♦
damaged during shipping, file a claim with the carrier and contact
ADTRAN Customer Support. Refer to
Module Insertion
NOTE
If present, remove the LMX DS3SM Blank (P/N 1184567G2) from
the appropriate slot of the LMX chassis.
Install the DS3SM module according to
Figure 149. DS3 Switch Module Insertion Diagram
61184500L1-5L
Figure
1. Open latch
2. Align module with
guide groove;
push firmly until
seated
Switch Module Installation and Turn-Up
"Appendix D,
149.
3. Close latch
Warranty".
251