Tributary Module Provisioning - ADTRAN OPTI-6100 Installation Manual

OPTI-6100 Installation and Turn-Up Practice
OC-12 Tributary Module Provisioning
Each tributary module has its own Provisioning menu tree. This section highlights some of the
items in the O12TME (P/N 1184544L1) menu tree needed to provision a new module.
To provision the O12TME module, complete the following steps:
1. From the OPTI-6100 Main menu, select
2. From the MS Modules menu, select the O12TME module to provision, and press
3. From the O12TME Line Card menu, select
4. From the Provisioning menu, select
5. From the Equipment Provisioned State menu, select
6. From the Provisioning menu, select
7. From the Facility Provisioned State menu, select
8. From the Service States menu, select
NOTE
AINS prevents alarms from being reported on facilities that are not
yet receiving a valid signal. Refer to
9. From the AINS Timer menu, select
10. From the Service States menu, select
11. On the AINS Time screen, enter the number of hours and minutes, and press
330
, and press
MS Modules
, and press
Provisioning
Equipment Provisioned State
IS,
Facility Provisioned State
, and press
IS
, and press
AINS Timer
"Auto In-Service"
, and press
Enable E
NTER
, and press
AINS Time
.
E
NTER
.
E
NTER
, and press
E
NTER
and press .
E
NTER
, and press .
E
NTER
to place the facility IS.
E
NTER
.
E
NTER
on page 332.
.
.
E
NTER
.
E
NTER
.
.
E
NTER
61184500L1-5L