Ethm8Eh/Ethm8Hf Provisioning - ADTRAN OPTI-6100 Installation Manual

ETHM8EH/ETHM8HF Provisioning

Use this Provisioning procedure to provision the following modules:
ETHM8EH (P/N 1184545L1)
♦
ETHM8HF (P/N 1184545G2)
♦
To provision the ETHM8EH/ETHM8HF module, complete the following steps:
1. From the OPTI-6100 Main menu, select
2. From the MS Modules menu, select the Ethernet module to provision, and press
3. From the ADTRAN Ethernet Line Card menu, select
4. From the Provisioning menu, select
5. From the Equipment Provisioned State menu, select
6. From the Provisioning menu, select
NOTE
AINS prevents alarms from being reported on facilities that are not
yet receiving a valid signal. Refer to
7. From the AINS Timer menu, select
8. From the Provisioning menu, select
9. On the AINS Time screen, enter the number of hours and minutes, and press
10. To manually provision an individual port's Speed, Duplex, and Crossover settings:
a. From the Provisioning menu, select
b. From the Port # Provisioning menu, select
c. From the Speed menu, select
NOTE
If either 100 Mbps or 10 Mbps is specified, the far end of the Ethernet
link must also be configured for the matching Speed and Duplex
settings. Duplex, Speed, and Auto-MDIX/Crossover Negotiation are
all automatically disabled if Speed is not set to Auto Negotiate.
d. From the Port # Provisioning menu, select
e. From the Duplex menu, select
f. From the Port # Provisioning menu, select
If Speed is set to Auto Negotiate, select
◊
If Speed is not set to Auto Negotiate, and a crossover cable is required, select
◊
NOTE
Auto Crossover eliminates the need to have both straight and
crossover cables.
61184500L1-5L
, and press
MS Modules
Equipment Provisioned State
, and press
AINS Timer
"Auto In-Service"
, and press
Enable
, and press
AINS Time
Port # Provisioning
, and press
Speed
,
Auto Negotiate 100 Mbps
, and press
Duplex
or
Full Duplex/Auto Half Duplex Only
Crossover
None/Auto
Tributary Module Installation and Turn-Up
.
E
NTER
, and press
Provisioning
, and press
E
, and press .
IS E
NTER
.
E
NTER
on page 332.
.
E
NTER
.
E
NTER
, and press .
E
NTER
.
E
NTER
, or , and press
10 Mbps
.
E
NTER
, and press
, and press .
E
NTER
to enable Auto-detect.
.
E
NTER
.
E
NTER
.
NTER
.
E
NTER
.
E
NTER
.
E
NTER
.
Forced
301