Omm12 Module Provisioning - ADTRAN OPTI-6100 Installation Manual

OMM12 Module Provisioning

All OMM12 modules must be provisioned to be put into service. In particular, equipment and
facilities must be put into service, and STS circuits assigned to the equipped mid-speed groups.
To provision the OMM12 module, complete the following steps:
1. From the OPTI-6100 Main menu select
NOTE
These instructions are for the module in slot HS1. With the exception
of the STS mapping, these settings must be repeated for HS2.
2. From the ADTRAN OMM-12 menu, select
3. From the Provisioning menu, select
4. From the Service States menu, select
5. From the Equipment menu, select
6. From the Service States menu, select Facility, and press
7. From the Facility menu, select
8. From the Service States menu, select
NOTE
AINS prevents alarms from being reported on facilities that are not
yet receiving a valid signal. Refer to
9. From the AINS Timer menu, select
10. From the Service States menu, select
11. On the AINS Time screen, enter the number of hours or minutes, and press
12. From the Service States menu, select the Path to put In Service, and press
13. From the Path [n] menu, select
14. If provisioning at the VT level, select
15. Select the VT to place In Service, and press
16. From the VT [n] menu, select
17. Press the appropriate number of times to return to the Provisioning menu.
E
SC
18. From the Provisioning menu, select
19. From the STS-1 Mapping menu, select the STS-1 to select the payload type, and press
.
E
NTER
20. From the STS-1 Payload Type menu, select the payload type for the STS-1, and press
21. From the STS-1 Mapping menu, select the STS to be mapped, and press
22. From the Select Drop menu, select the MS slot to be mapped to the STS, and press
61184500L1-5L
HS1 - [module type]
Provisioning
, and press
Service States
, and press
Equipment
, and press
IS E
, and press
IS E
NTER
, and press
AINS Timer
"Auto In-Service"
, and press
Enable
, and press
AINS Time
, and press
IS E
NTER
, and press
Path #[n] VTs
.
E
NTER
, and press to place the VT In Service.
IS E
NTER
, and press
STS-1 Mapping
OMM Module Installation and Turn-Up
, and press
E
NTER
, and press .
E
NTER
.
E
NTER
.
E
NTER
to place the module In Service.
NTER
.
E
NTER
to place the facility In Service.
.
E
NTER
on page 332.
.
E
NTER
.
E
NTER
to place the Path In Service.
.
E
NTER
.
E
NTER
.
.
E
NTER
.
E
NTER
.
E
NTER
.
E
NTER
.
E
NTER
231