OPTI-6100 Installation and Turn-Up Practice
11. To set the Facility service state, complete the following procedure:
a. From a Port Provisioning menu, select
b. From the Facility Provisioning menu, select
Table 152
on page 302 lists the minimum factory defaults and values that are loaded after
installation and self-test for the ETHM8EH/ETHM8HF modules.
Table 152. ETHM8EH/ETHM8HF Provisioning Options
Provisioning Options
Equipment Provisioned State
AINS Time
AINS Timer
VLAN Mode
Protocol ID (Double Tag only)
Port Provisioning Options (VLAN Mode noted):
Peak Rate (Transparent, Double Tag)
Committed Rate (Double Tag only)
VLAN Uplink Tag (Double Tag only)
VLAN Uplink (Double Tag only)
Translation #1–6, Untagged Translation
(Translation only)
Speed
Duplex
Crossover
Protocol
Pause Frames
Burst Size
Refer to
"Appendix C, Advanced Ethernet Provisioning"
provisioning options.
302
Facility Provisioning
, and press
IS
Settings
IS
♦
OOS-MA
♦
1 Minute to 96 Hours; 4:00 is the default
Enabled
♦
♦
Disabled (default)
♦
Transparent (default)
Translation
♦
0×9100 (default)
♦
0×8100
♦
5 – 100000 or Full Rate; Full Rate is the default
0 – <remaining VCG bandwidth>; 0 is the default
1 – 4093; 1 is the default
1 is the only option
The only option is Inactive
Auto Negotiate (default)
♦
10 Mbps
♦
Full Duplex/Auto (default)
♦
♦
Half Duplex Only
♦
None/Auto (default)
Forced
♦
GFP (default)
♦
X.86
♦
♦
Enabled (default)
♦
Disabled
32 – 4194 kb; 64 is the default
for more details on various Ethernet
, and press
.
E
NTER
.
E
NTER
OOS-MA UAS (default)
♦
Double Tag
♦
♦
Other
♦
100 Mbps
♦
61184500L1-5L