View - Nellcor N-395 Operator's Manual

Scrolling past the limits of the right or left edges of the screen
causes the viewing area to shift, relocating the cursor to the
middle of the screen if enough trend data is available.
For example, suppose the time represented by the right-hand
edge of the screen in Figure 13 is 14:54:05. Scrolling one tiine
period to the right (4 minutes) results in the cursor relocating to
the center of the screen at the time period 14:58:05, with 6 hours
of data on both sides of the cursor. If no data were available to
the right of the screen, an invalid tone would sound. If only 3
hours of data was to the right of the screen, the cursor would
relocate to approximately 314 of the way to the right of the
screen, at the tiine period 14:58:05.
Note: The screen will return to the monitoring mode if an
alarm sounds, the ALARM SILENCE Button is pressed
or a trend or histogram has been displayed for 5 iniiiutes
with no button presses.
View
Pressing the VIEW softkey allows selection of the following
trend displays: DUAL, SP02, PULSE, HIST, or AMP. To
select HIST or AMP press VIEW, then NEXT.
Dual Trend Display
The dual trend display provides trend information on the %SpOz
and pulse rate. See Figure 14.
Figure 14: Dual Trend Display