Recharging The Battery Pack - Agilent Technologies AuroraPresto User Manual

Table of Contents

Advertisement

Recharging the Battery Pack

Warning: Recharging the battery
Only recharge the rechargeable NiMH battery pack
supplied with your
You must not recharge the battery if the temperature is
below 0°C or above +35°C.
-1- Plug the power adaptor/charger into the mains supply
Warning: Using the adaptor/charger
AuroraPresto
charger with which it is supplied. If you use any other
adaptor/charger, you may damage the tester or battery, and
invalidate equipment warranties and approvals relating to
safety or electromagnetic compatibility.
The battery is initially charged at a high current ('fast
charging'). This means it will be almost fully charged in 2-3
hours.
During fast charging, the Bat LED lights up bright green.
Tip
You can use
You can also disconnect the adaptor/charger at any time
during the charging cycle: when you reconnect, a new cycle
begins.
-2- Continue until the battery is fully charged.
When fast charging is complete, the Bat LED glows green
less brightly. The battery is now being charged in 'pulses'.
This is the 'top off' stage, which ensures that the battery is
fully charged: it lasts for 3 hours.
When charging is complete, the LED glows green very
dimly, to indicate that the battery is being 'trickle charged'.
Issue 7 - 05/02
AuroraPresto
AuroraPresto
and
is intended for use only with the adaptor/
AuroraPresto
.
's power supply socket.
while the battery is recharging.
Power Sources
6-5

Advertisement

Table of Contents
loading

Table of Contents