Table of Contents
Advertisement
AuroraPresto—User Guide
Caution: TDR/DMM Tests
When performing Capacitance and Load Coil tests make
sure that voltage is NOT present on the line, if a voltage is
present on the line you may damage
The Current test is intended for low DC current
measurement only. It is protected by a 400mA fuse.
The TDR/DMM module has protection devices fitted at
manufacture that cannot be reset by the user. If the
protection devices are activated
returned to Agilent Technologies for repair.
• Setting up DMM Tests—The DMM test is a physical
layer test. See
• Setting up TDR Tests—See
on page 4-26.
• Setting up DSL Tests—See
Tests
• Setting up Ping Tests—See
on page 4-86.
• Setting up ATM BERT Tests—See
BERT
• Setting up F5 OAM PING Tests—See
OAM Ping Test
Setting up DSL Test Profiles
Auto Test Mode has 3 DSL Test Profiles. You can assign
Hot Key profiles to each DSL Test Profile. See
AuroraPresto Using Hot Keys
information on setting up the Hot Key profiles.
-1- From the Select Test Mode screen, choose
4-4
Setting up DMM Tests
on page 4-33.
on page 4-59.
on page 4-68.
Auto Tests and press ENTER to display the
Select Tests screen.
AuroraPresto
AuroraPresto
must be
on page 4-22.
Setting Up the TDR Tester
Setting up DSL Layer
Setting up the IP Ping Test
Setting up an ATM
Setting up the
Setting up
on page 3-2 for
.
481801
Advertisement
Table of Contents
