Table of Contents
Advertisement
AuroraPresto—User Guide
When the battery is fully recharged, it is safe to leave the
charger connected for longer periods. If you do this, it
continues 'trickle charging' the battery to maintain full
capacity, and the Bat LED glows green very dimly.
Note
Avoid 'force charging'
removing and inserting the charger—this may cause
excessive heat in the tester and reduce the capacity of the
battery.
Replacing a Battery Pack
It may be useful to carry spare battery packs with you, in
case the battery runs out at a site where no mains power is
available. Keep them in the carrying case until needed.
While you are replacing the battery, the real-time clock and
system settings are maintained by a memory backup
capacitor. This should ensure that the settings are retained
even if
hours.
To remove the old battery
Warning
Disconnect all cables before removing the battery cover.
-1- Remove the battery pack cover, which is on the back
6-6
AuroraPresto
is left without a battery for several
AuroraPresto
of
. To do this:
Loosen the screw by turning it anticlockwise
•
using a coin or screwdriver.
•
When the screw is completely released, it pops
up. Slide the cover upwards to remove.
AuroraPresto
by repeatedly
481801
Advertisement
Table of Contents
