G.SHDSL Loopbacks
To send a G.SHDSL Loopback:
-1- From the Select Test Mode select Manual Tests to
-2- Choose DSL Layer. The following screen is displayed.
-3- Choose DSL Loopbacks to display the Loopbacks
Issue 7 - 05/02
display the Select Operation screen.
screen.
Addr—Enter an Embedded Operations Channel.
•
Cmd—Sends a command to the Far-End.
•
Direction—Use to set up the loop direction from
•
customer to network or network to customer.
Result—NOK indicates that the results are not
•
OK.
Section 4 - DSL Layer Tests
4-49