Table of Contents
Advertisement
AuroraPresto—User Guide
Making sure that the test is working properly
At the start of the test, you can inject a single bit error into
the data stream and check that it is detected. To do this:
-1- Press F4 Error.
-2- Check that the error has been detected and is
-3- Press F2 Reset to reset the counters to zero and begin
Stopping the test manually
You can stop a BER test manually at any time. You might
do this when Duration is Continuous and you want to end
the test, or when you want to perform a new test with
different BERT settings.
-1- Press F1 Stop.
4-80
displayed.
Press F3 Clear to reset the BERT LED.
the 'real' test.
AuroraPresto
stops the test and the results are
displayed.
Use the UP and DOWN keys to scroll through the
on-screen results.
481801
Advertisement
Table of Contents
