Configuring The Serial Port - Agilent Technologies AuroraPresto User Manual

AuroraPresto—User Guide
ATM
BERT
Ping
Trace Route
IP
PPP

Configuring the Serial Port

AuroraPresto
which is used to connect the tester to another device such as
a PC or printer. For example, you would connect to a PC to
transfer results. See
and receiving data using a PC.
To configure the serial port:
-1- From the Main Setup menu, select Serial Comms to
3-8
Use to set up VPIs (Virtual Path
Identifiers) and VCIs (Virtual
Identifiers). See
(Virtual Path Identifiers) and VCIs
(Virtual Channel Identifiers)
page 4-52.
Use to set up the BERT settings.
See
page 4-59.
Use to set up the Ping network mode,
Destination address and Ping settings.
See
page 4-86.
Use to set up Dst (Destination IP
Address), Max TTL (Time to Live)
and Timeout.
Use to set up the IP Options.
Use to set up PPP Type,
Authentication Method, Password,
User and Tracer.
has a two-way, high speed RS232 serial port,
Chapter 5
display the Serial Setup screen.
Setting up VPIs
Setting up an ATM BERT
Setting up the IP Ping Test
for information on sending
Channel
on
on
on
481801