AuroraPresto
OR
Simulating Modem to a DTE
You can use
locally attached DTE over the Ethernet 10 Base T interface
and to test the operation of the DTE and its interface to the
modem.
Note
Before you can begin testing, you must connect
AuroraPresto
or IP terminal using an Ethernet IP cross-over cable. See the
following diagram.
DTE
AuroraPresto to PC Ping test configuation
For key see
See
IP Ping Test
Issue 7 - 05/02
can be configured:
•
as a local modem to the network (DSLAM) to
test the ADSL physical layer
•
to simulate a DTE and local modem to the
Network (DSLAM) and remote DTE to test the
ADSL and the Network Layer.
AuroraPresto
's 10 Base T interface to the PC Ethernet card
10 Base T
(Ethernet)
AuroraPresto replacing
diagram
on page 4-85.
Section 2 - DSL Testing Techniques
to perform a Ping test of the
ATU-R
on page 4-10.
4-13