Table of Contents
Advertisement
AuroraPresto—User Guide
Setting up a VPI/VPC for the BERT
You can set up a dedicated VPI/VCI for the ATM 25 BERT.
Note
The VPI/VCI that you enter for the ATM 25 BERT must not
be the same as any of the four VPI/VCIs set up for the ATM
layer.
-1- Use the UP and DOWN keys to select VPI from the
-2- Enter a VPI number between 0 and 255.
Setting up a VCI for the BERT
-1- Select VCI from the BERT setup menu to display an
-2- Enter a VCI number between 0 and 65535.
Setting up BERT%
The BERT VC is a dedicated VC and not one of the four
ATM Layer Test VCs. It shares the same bandwidth pool as
the four VCs. It can be used to transmit data above its
selected available bandwidth when one or more of the four
VCs is not transmitting data.
Note
Data speeds will always be limited by the narrowest
available bandwidth on an end-to-end connection. For cells
generated on the ATM25 interface, transmitted over ADSL,
the maximum rate will be 8Mbps.
4-78
BERT setup menu to display an entry window.
entry window.
481801
Advertisement
Table of Contents
