Table of Contents
Advertisement
Note
If your
Protocol Setup is always set to Bridged.
Setting up the IP Port
This option is only available if you have set the IP Mode to
Routed or PPP.
-1- Select Port from the IP Setup menu.
-2- Choose 10BT if you are using an Ethernet connection.
-3- Press ENTER to save the changes.
-4- Press ESC to exit the IP Setup screen.
Setting up the LAN Address
This option is used to set up
LAN (Ethernet) side of the network.
This option is only available if you have set up the IP Mode
to Routed.
-1- Select LAN Address from the IP Setup screen and
Adr
Issue 7 - 05/02
AuroraPresto
does not have the PPP Option, the
A screen similar to the following is displayed.
The default is None, you must select a port.
Choose a VC if you are using an ADSL connection.
press ENTER to display the LAN Address screen.
Use this to set up the Address that
AuroraPresto
(Local Area Network).
Setting up AuroraPresto
AuroraPresto
's address on the
will use on the LAN
3-17
Advertisement
Table of Contents
