Table of Contents
Advertisement
-1- Select Threshold from the BERT setup menu.
The BER display shows the error rate that applies if the
currently selected number of errors occur within the
selected test time. The rate is shown as x.yE-z, where E-z
means 10 to the power of z. In the above example, the rate
is 1.0x109.
-1- If the following screen is displayed,
To set the threshold as a number of errors:
-1- Select Errors from the Threshold screen to display
-2- Enter a number of errors between 1 and 100 and press
Issue 7 - 05/02
press F1 On to enable the threshold.
an entry window.
ENTER.
Section 6 - Datalink
4-75
Advertisement
Table of Contents
