Table of Contents
Advertisement
Upstream
The following options are only available if an ATU-C
and
interface is fitted to your
Downstream
selected ATU-C mode.
Parameters
• Max Add NM dB—Enter the Maximum Noise
(ATU-C
only)
• Min NM dB—Enter the Minimum Noise Margin
• Target NM dB—Enter the Noise Margin that you
Enter a value between 0 and 9000 kbps, in 32 kbps
increments, for the following options:
• Min FBR kbps—Minimum Fast Bit Rate.
• Max FBR kbps—Maximum Fast Bit Rate.
• Min IBR kbps—Minimum Interleaved Bit Rate.
• Max IBR kbps—Maximum Interleaved Bit Rate.
Downstream only
• Max PSD—Maximum Power Spectral Density. The
Tracer
Enables you to choose to display or not to display ADSL,
PPP and G.SHDSL messages.
Choose Tracer None to disable ALL the Tracer options.
Choose Tracer ALL to enable ALL the Tracer options.
The default is Off.
Choose Trace DSL to trace DSL events.
Choose Trace DSL Alms to trace DSL Alarms
(G.SHDSL only).
Choose Trace EOC to trace EOC events (G.SHDSL
only).
Choose Trace PPP to trace PPP events.
Parameters
This option is only available if you have a G.SHDSL
(G.SHDSL
interface card fitted and you have selected GL STU R or
only)
G STU C in the Type option. See
page 4-42 for details on setting up G.SHDSL tests.
Issue 7 - 05/02
Margin above the Target Noise Margin for the
modem to stay in steady state.
below the Target Noise Margin for the modem to
stay in steady state.
want the modem to achieve to activate successfully.
maximum ATU-C downstream power.
Setting up AuroraPresto
AuroraPresto
and you have
G.SHDSL Tests
on
3-13
Advertisement
Table of Contents
