Table of Contents
Advertisement
-3- Press F4 Setup to display the OAM Ping Setup
Src
Dst
Port
Type
Pings
Timeout
Delay
Setting up the Destination Address
-1- Select Other Tests from the Select Test Mode screen
-2- Press F4 Setup and select Dst Addr.
Issue 7 - 05/02
screen.
Use this to set up
Source Address for the Ping response.
Use this to set up the Destination
Address (for Segmented Pings only).
Choose a VC (VC1 to VC4).
Only VCs which have been mapped
and enabled by
displayed.
Choose Segmented or End-to End.
You must specify an ATM Destination
Address if you choose Segmented.
Enter the number of Pings to be sent
between 0 to 10000 (0 = continuous).
Enter a timeout length between 500 to
5000ms. This is the length of time
AuroraPresto
ping before it assumes that a reply will
not be received.
Enter the delay in seconds between
successive Pings. The minimum is 5
seconds.
and choose OAM Ping Test.
Section 5 - ATM Layer Tests
AuroraPresto
's ATM
AuroraPresto
are
waits after sending a
4-69
Advertisement
Table of Contents
