AuroraPresto—User Guide
-2- Select Type and press ENTER to display the
Type
This displays the interface cards that are fitted to your
AuroraPresto
ADI ATU-R(I), ADI ATU-R(P), AL ATU-R(I),
AL ATU-R(P), AL ATU-C(P) or TI ATU-R(I) and for
G.SHDSL tests, choose GL STU R or G STU C.
Mode
This enables you to select the available modes. Choose
GLITE, AUTO Fast or AUTO Intlv for ADSL tests and
Auto, Annex A or Annex B for G.SHDSL tests
depending on the modem.
If you choose Auto,
the correct regional setting.
Training
Use to set the modem training to Automatic or Manual.
Up Nm/Attn
Use to enable or disable the Upstream Noise Margin and
(ADI ATU-R
Attenuation parameters.
only)
Dn Nm/Attn
Use to enable or disable the Downstream Noise Margin
(ADI ATU-R
and Attenuation parameters.
only)
Note
Some DSLAMs do not support Noise Margin and
Attenuation parameters.
3-12
following screen.
. For example, for ADSL tests, choose
AuroraPresto
•
For accurate results, you must choose enable
for ADI based DSLAMs that support Noise
Margin and Attenuation parameters.
•
For accurate results, you must choose disable
for DSLAMs that do not support Noise
Margin and Attenuation parameters.
automatically chooses
481801