Running the Noise Analysis Test
Note
The ADSL Layer must be down before you start the Noise
Analysis Test. Synchronise the DSL, see page 4-34.
-1- From the Select Test Mode screen select Manual
-2- Select Physical Layer to display the following screen.
-3- Select Noise Analysis to display the following
-4- Press F1 Start. The following screen is displayed.
Issue 7 - 05/02
Tests to display the Select Operation screen.
screen.
When the Noise Analysis test has finished a screen
similar to the following is displayed.
Press ESC to display the previous screen.
From the previous screen, press F2 View to display
the graph screen again.
Section 3 - Physical Layer Tests
4-19