Table of Contents
Advertisement
-2- Turn the cover over to show the belt hook release
-3- Remove the bolt from its holder. To do this:
-4- Remove the belt hook from the top of the cover.
-5- Replace the bolt in its holder by sliding it back in and
Warning: Belt hook bolt
Always keep the bolt in its holder. If you lose it you will not
be able to replace the belt hook, and the case will not be
water-resistant.
-6- Replace the battery pack cover:
Warning: Tightening the screw
Make sure the screw is tight enough to avoid the cover
coming off when you try to hang up
belt hook.
Issue 7 - 05/02
mechanism. The hook is held in place by a small bolt.
•
Release the bolt by pushing it upwards.
•
Slide the bolt out of its holder.
pushing down to secure it in place.
•
Slide the cover back down into place.
•
Push the screw down and turn it clockwise to
tighten.
Section 1 - Preparing to Use AuroraPresto
AuroraPresto
from its
2-9
Advertisement
Table of Contents
