Table of Contents
Advertisement
AuroraPresto—User Guide
-1- Connect
Setting up AuroraPresto - Software
Version A1.05 or Earlier
Tip
To check the current software version, press
details see Checking the Current Setup of
Chapter 3 of the main
Setting up the IP Address
-1- From the Select Test Mode screen, press F4 Setup.
-2- Select IP Setup to display the options:
-3- Enter an IP Source Address (Src) and Default
-4- Enter a Subnet Mask (Msk).
-5- Select IP Type and choose Dix.
-6- Press ESC to accept the settings and exit the IP Setup
-7- Press ESC again to return to the Select Test Mode
3-44
AuroraPresto
cable supplied.
If the connection has been made, the LED on the PC
Ethernet card will be lit.
If the connection is direct you will need a 'crossover'
cable (Part No: 437353).
If the connection is via a
'straight' cable (Part no: 437352).
These cables are supplied with
Gateway (DGW).
Enter 000.000.000.000 if you do not know the
Default Gateway.
Enter 255.255.000.000 if you do not know the
Subnet Mask.
screen.
screen.
to the PC using the Ethernet
LAN
you will need a
AuroraPresto
AuroraPresto
User Guide.
.
+ 5. For
AuroraPresto
in
481801
Advertisement
Table of Contents
