Modem Tests; Simulating A Dte (Data Terminal Equipment) - Agilent Technologies AuroraPresto User Manual

Modem Tests

Simulating a DTE (Data Terminal Equipment)

Issue 7 - 05/02
Tip
• To check the current setup, press
details, see Checking the Current Setup of
AuroraPresto
AuroraPresto
enables you to test the ADSL layer, the
ATM layer and the IP layer. Any Application Layer
traffic is transparent to
operating in Golden Modem Mode.
AuroraPresto
You can use
interface to connect to the local modem when
simulating a DTE. You can also use the optional
ATM25 interface, if fitted, to connect to the local
modem.
You can configure
the local bridged modem (if the modem has an IP
address). For an End-to-End configuration, you can
AuroraPresto
also configure
local bridged modem through the network and to a
remote DTE.
AuroraPresto
can test a DTE to modem connection
without the ADSL connection being active.
AuroraPresto
sends an IP Ping to the modem's IP
address.
AuroraPresto
can send an ATM BERT pattern on the
ATM25 interface to the ATU-R.
AuroraPresto
can be used to test, locate and display
the following faults:
• IP routing
These can be caused by faults to and from the
LAN or DTE to the Wide Area Network.
Section 2 - DSL Testing Techniques
on page 3-41.
AuroraPresto
's Ethernet 10BaseT
AuroraPresto
to simulate a DTE to
to simulate a DTE via the
+ 5. For
when it is
4-11