Table of Contents
Advertisement
Training
Modem
Connect
Opened
Trying G.LITE
Note
ATU Mode
ANSI
ATU Mode
G.DMT
ATU Mode
G.LITE
ATU Mode
Unknown
Note
Close REQ
Connect
Closed
Issue 7 - 05/02
AuroraPresto
has detected a peer ATU and is training.
AuroraPresto
has successfully trained and opened a
connection to the peer ATU (for example, Showtime).
AuroraPresto
, configured as an ATU-C in AUTO
mode, has detected a G.LITE device (for example,
failed to open in full rate mode due to a parameter
mismatch) and will reattempt the open in G.LITE
mode.
This is how the Alcatel firmware implements
multimode opens. A transition through IDLE (with a
corresponding trace message) is followed after a
timeout of approximately 5 seconds by an Open
AUTO G.LITE.
After successfully training the device on the far end
was determined to be operating in (ANSI T1.413)
mode.
After successfully training the device on the far end
was determined to be operating in G.DMT ITU
(G.992.1) mode.
After successfully training the device on the far end
was determined to be operating in G.LITE ITU
(G.992.2) mode.
After successfully training, the mode the device on the
far end was operating in could not be determined.
This message is included for completeness and will
only occur if the device on the far-end does not
properly identify itself as one of the above types.
A request to close an active connection.
A connection was successfully closed.
ADSL Status Messages & Vendor Codes
A2-5
Advertisement
Table of Contents
