Table of Contents
Advertisement
Setting up the IP Operation Mode
-1- Select IP Mode from the Framing Setup menu.
-2- Choose Bridge Type1or Bridge Type7.
Setting up the IP
-1- Select HDR Compression from the Framing Setup
-2- Choose On to enable header compression
-3- Press ENTER to accept the entry.
Setting up the NAT
(Network Address Translation) and
PAT (Port Address Translation)
The NAT option is used to translate IP addresses that are
not globally unique and cannot be connected directly to the
Internet. These IP addresses are translated and can then be
used to connect to the Internet. NAT is used when you want
to connect to one device.
Issue 7 - 05/02
A screen similar to the following is displayed.
If you choose Bridge Type1,
the Frame Check Sum (FCS). If you choose
Bridge Type7,
AuroraPresto
Header
menu.
A screen similar to the following is displayed.
OR
Off to disable header compression depending on how
the network is set up.
Setting up AuroraPresto
AuroraPresto
discards the FCS.
Compression
preserves
3-23
Advertisement
Table of Contents
