Binary Outputs - Siemens SICAM Q100 7KG95 Series Manual

16.1.3

Binary Outputs

Source type
Source Type Indication
Indication
(only if source type = indication)
NOTES
Only the indications for the parame-
terization of the binary outputs are
displayed which can be used
according to the current device set-
tings.
Indications which are read by
Modbus slave devices are available
in the list box if they were parame-
terized in Modbus Master Mapping.
Source inverted
SICAM Q100, 7KG95xx, Device Manual
E50417-H1040-C522-A6, Edition 06.2019
Parameter Default Settings
Indication
-none-
no
16 Operating Parameters
16.1 Process Connections
Setting Range
Indication
Energy counter
-none-
Device OK
Battery Failure
Settings Load
Settings Check
Settings Activate
Modbus TCP OK
Ethernet Link Error
Time Synchronization Error
Primary NTP Server Error
Secondary NTP Server Error
Daylight Saving Time
Ethernet Link 2 Error
Default IP Address
Limit Violation x (x = 1 to 16)
Indication 1 from Remote
Indication 2 from Remote
Rotation Voltage Clockwise
Group Indication x (x = 1 to 4)
IEC 61850 Communication OK
SD Card Error
Voltage Event Available
Frequency Event Available
Voltage-Unbalance Event Available
Indication x from Remote (x = 3 to 14)
SICAM Subdevice 1 OK
SICAM Subdevice 2 OK
Binary Input x-N SICAM IO 1 (x = 1 to 3)
Binary Input x-P SICAM IO 1 (x = 1 to 3)
Binary Input x-N SICAM IO 2 (x = 1 to 3)
Binary Input x-P SICAM IO 2 (x = 1 to 3)
Load profile period closed
Load profile synchr. period
Load profile tariff x (x = 1 to 8)
*)
Binary input 1
*)
Binary input 2
Modbus RTU Master OK
New MSV record made
Indication x Slv y (x = 1 to 6; y = 1 to 8)
MQTT communication OK
*)
Designation can be changed during
the parameterization.
no
yes
*)
*)
*)
*)
*)
*)
*)
401