Siemens SICAM Q100 7KG95 Series Manual page 237

Parameterizing the Serial Communication with Modbus RTU (Slave) or Modbus RTU Master
To change the serial communication settings, proceed as follows:
✧
In the navigation window, select the Administrative menu and click Communication serial.
The Communication serial input/output window opens.
✧
In the list box select Bus protocol.
If you select -none-, no protocol will be available. Click Send in this case.
Figure 9-68
Figure 9-69
SICAM Q100, 7KG95xx, Device Manual
E50417-H1040-C522-A6, Edition 06.2019
Configure Tab, Communication Serial via Modbus RTU Input/Output Window
Configure Tab, Communication Serial via Modbus RTU Master Input/Output Window
9 Operation at Use of a PC
9.3 Configuration of the Device
237