Siemens SICAM Q100 7KG95 Series Manual page 355

Table 10-7
Current - Deadband
Power - Deadband
Power factor - Deadband
Frequency - Deadband
1) After enabling the parameter changes, any currently active Modbus TCP connections will be closed. The
Modbus TCP client must later re-open these connections.
Table 10-8
Bus protocol
Device address
Baud rate
Parity
Access rights
Communication supervision time
Baud rate
Parity
Additional inter-character timeout
Maximum 0x/1x register gap
Maximum 3x/4x register gap
SICAM Q100, 7KG95xx, Device Manual
E50417-H1040-C522-A6, Edition 06.2019
Ethernet Communication Settings (cont.)
Serial Communication Settings – Modbus RTU and Modbus RTU Master Bus Protocols
Parameter
Bus Protocol Modbus RTU (Slave)
Bus Protocol Modbus RTU Master
5 % 1 % to 5 % in increments of 1 %
5 % 1 % to 5 % in increments of 1 %
5 % 2% to 5 % in increments of 1 %
0,05 0.02 %
0.05 %
Default Setting
Modbus RTU None
Modbus RTU
Modbus Master
1 1 to 247
19 200 bit/s For the selection, see chapter 16
Even For the selection, see chapter 16
Full Full
Read only
600 * 100 ms 0 s = none
100 ms to 6 553 400 ms
19 200 bit/s For the selection, see chapter 16
even For the selection, see chapter 16
1 ms 0 ms to 100 ms
40 0 to 200
10
10 Operation at Use of the Display
10.4 Parameterization
Setting Range
355