Siemens SICAM Q100 7KG95 Series Manual page 433

Parameter/Indications
Parameter: Source of output 1-N
Indication: Input 1-N
Parameter: Source of output 2-N
Indication: Input 2-N
Parameter: Source of output 3-N
Indication: Input 3-N
Parameter: Source of output 1-P
Indication: Input 1-P
Parameter: Source of output 2-P
Indication: Input 2-P
Parameter: Source of output 3-P
Indication: Input 3-P
SICAM Q100, 7KG95xx, Device Manual
E50417-H1040-C522-A6, Edition 06.2019
Default Setting
Indication 9 from Remote
Binary inp. 1-N SICAM IO 1
Indication 10 from Remote
Binary inp. 2-N SICAM IO 1
Indication 11 from Remote
Binary inp. 3-N SICAM IO 1
Indication 12 from Remote
Binary inp. 1-P SICAM IO 1
Indication 13 from Remote
Binary inp. 2-P SICAM IO 1
Indication 14 from Remote
Binary inp. 3-P SICAM IO 1
16 Operating Parameters
16.6 Administrative
Setting Range
Parameter: Source of output
(depending on parameterization):
-none-
Device OK
Battery Failure
Settings Load
Settings Check
Settings Activate
Modbus TCP OK
Ethernet Link Error
Time Synchronization Error
Primary NTP Server Error
Secondary NTP Server Error
Daylight Saving Time
Ethernet Link 2 Error
Default IP Address
Limit Violation x (x = 1 to 16)
Indication 1 from Remote
Indication 2 from Remote
Rotation Voltage Clockwise
Group Indication x (x = 1 to 4)
IEC 61850 Communication OK
SD Card Error
Voltage Event Available
Frequency Event Available
Voltage-Unbalance Event Available
Indication x from Remote (x = 3 to 14)
SICAM Subdevice 1 OK
SICAM Subdevice 2 OK
Binary Input x-N SICAM IO 1 (x = 1 to
*)
3)
Binary Input x-P SICAM IO 1 (x = 1 to
*)
3)
Binary Input x-N SICAM IO 2 (x = 1 to
*)
3)
Binary Input x-P SICAM IO 2 (x = 1 to
*)
3)
Load profile period closed
Load profile synchr. period
Load profile tariff x (x = 1 to 8)
*)
Binary input 1
*)
Binary input 2
Modbus RTU Master OK
New MSV record made
Indication x Slv y (x = 1 to 6; y = 1 to
*)
8)
MQTT communication OK
Indications which are read by
Modbus slave devices are available
in the list box if they were parameter-
ized in Modbus Master Mapping.
*)
Designation can be changed
during the parameterization.
Indication Input:
Indication: any, max. 31 characters
*)
*)
433