Assembly - Siemens SICAM Q100 7KG95 Series Manual

7 Getting Started

7.2 Assembly

7.2.3 Assembly
To install the device into a switch panel, proceed as follows:
✧ Push the device in installation position into the cut-out of the switch panel and hold the device tight.
✧
Attach one of the supplied mounting elements each on both sides of the housing.
 1 mm (0.04 inch), steel
Figure 7-2
✧
Swing the mounting element (provided with the device) over the rear cone.
✧
Move the mounting element to the position. Use a screw driver (0.6 mm x 4.5 mm) to fix the mounting
elements until the slipping clutch takes effect.
NOTE
The above mounting instructions must be performed correctly to provide sufficient protection against touching
live parts.
UL-Certification Conditions
Field Wires of Control Circuits shall be separated from other circuits with respect to the end-use requirements!
116
Mounting plate
Mounting element
Stepwise Installation of the SICAM Q100 into a Switch Panel
SICAM Q100, 7KG95xx, Device Manual
E50417-H1040-C522-A6, Edition 06.2019