Communication Interfaces; Ethernet Interface; Rs485 Interface - Siemens SICAM Q100 7KG95 Series Manual

8 Connection Principle

8.2 Communication Interfaces

8.2 Communication Interfaces
8.2.1

Ethernet Interface

The Ethernet interface Z is located on the top side of the SICAM Q100. Data are exchanged via the
RJ45 Ethernet socket, see also detailed information in System Manual SICAM Q100 7KG95xx, order number
E50417-C1040-C482, chapter 2.
Ethernet socket
(RJ45)
Figure 8-2
NOTE
If you do not connect a cable to the RJ45 socket, Siemens recommends covering the socket with a cap or dum-
my plug (not included in the delivery) to prevent the contacts from becoming dirty.
If you use a Y cable and the internal Ethernet switch of the device, SICAM Q100 can be connected with a SI-
CAM I/O Unit. This device combination can be connected with the process control via the second connector of
the Y cable and an external Ethernet switch. For typical circuit diagrams, refer to the System Manual
SICAM Q100 7KG95xx, order no. E50417-C1000-C522, chapter 2.
8.2.2

RS485 Interface

The RS485 interface J (D-Sub) is located on the terminal side; see also detailed information in the System Man-
ual SICAM Q100 7KG95xx, order no. E50417-C1000-C522, chapter 2.
RS485 connector
(D-sub)
Figure 8-3
NOTE
If you do not connect a cable to the RS485 connector, Siemens recommends covering it with a cap (not includ-
ed in the delivery) to prevent the contacts from becoming dirty.
128
Ethernet Interface Z (Detail of the Top Side)
RS485 Interface J (Detail of the Terminal Side)
SICAM Q100, 7KG95xx, Device Manual
E50417-H1040-C522-A6, Edition 06.2019