Siemens SICAM Q100 7KG95 Series Manual page 371

Table 13-1
LED
RUN
H1
RUN
H1
RUN
H1
C
RUN
H1
C
RUN
H1
C
RUN
H1
C
SICAM Q100, 7KG95xx, Device Manual
E50417-H1040-C522-A6, Edition 06.2019
Indications Signaled by LEDs on the Top Side of the Housing
Device is switched off.
ERROR
H2
Device is switched on, but firmware is not loaded.
ERROR
or
H2
Device is in startup phase.
Configured IP address is used.
ERROR
or
IP address is received via DHCP.
H2
H1 and H2 LEDs are configured.
C
Normal operation with default IP address
ERROR
The default IP address was requested by pressing the F4 softkey during
normal operation.
H2
C
Double IP address has been detected in the network.
ERROR ERROR
The device is in operation but cannot be reached via Ethernet.
Solve this network configuration issue and restart the device.
H2
Each device must have a unique IP address.
C
An IP address request via DHCP is in progress.
ERROR ERROR
ERROR = off, H1 and H2 LEDs according to configuration
RUN LED stops flashing when IP address is received.
H2
C
The device runs into the Fallback mode after an unresolvable error in normal
operation occurs or by pressing the F4 softkey during device startup.
Meaning
No Operation
Normal Operation
13 Failures and LED Indications
13.2 Indications Signaled by LEDs
371