Siemens SICAM Q100 7KG95 Series Manual page 174

9 Operation at Use of a PC
9.3 Configuration of the Device
✧
Select the desired parameters in the list boxes and option fields as described in Table 9-5.
NOTE
Select Indication -none- to disable the corresponding LED.
✧
After the parameterization click Send.
The parameters are transmitted to the device but not enabled yet (passive set of parameters).
✧
If you do not want to make any additional settings, continue with the Activation of the device configuration
according to section Activating the Set of Parameters. If you want to change other settings, enter the
changes and then enable the device configuration as described in section Activating the Set of
Parameters.
Behavior of the LEDs
H
Indication
L
LED ON
Figure 9-32
174
Indication
OFF
Behavior of the LEDs
invalid invalid
flash flash
SICAM Q100, 7KG95xx, Device Manual
E50417-H1040-C522-A6, Edition 06.2019