Siemens SICAM Q100 7KG95 Series Manual page 354

10 Operation at Use of the Display
10.4 Parameterization
Table 10-6
MAC address
1)
IP address
1)
Subnet
1)
Gateway
1) After the communication parameters have been changed, the device restarts. For this purpose, a prompt
is displayed which you must acknowledge with Ok.
Table 10-7
Bus protocol
Access rights for port 502
Keepalive time
Communication monitoring time
Use user port number
User port number
(only settable if Set user port number
is parameterized with yes)
Access right for user port
(only settable if Set user port number
is parameterized with yes)
IED Name
Voltage - Deadband
354
IP Address Settings
Parameter
Ethernet Communication Settings
Parameter
Ethernet Communication - Modbus TCP Bus Protocol
1)
1)
Ethernet Communication - IEC 61850 Bus Protocol
Default Setting
fixed
192.168.0.55 Any
0.0.0.0 = DHCP
255.255.255.0 Any
192.168.0.1 Any
Default Setting
Modbus TCP none
Modbus TCP
IEC 61850
Both
full full
read only
10 s 0 s = switched off
1 s to 65,535 s
600 * 100 ms 0 s = none
100 ms to 6 553 400 ms
No No
Yes
10 000 10 000 to 65 535
full full
read only
SICAM_Q100_01 read only
5 % 1 % to 5 % in increments of 1 %
Setting Range
Setting Range
SICAM Q100, 7KG95xx, Device Manual
E50417-H1040-C522-A6, Edition 06.2019