Siemens SICAM Q100 7KG95 Series Manual page 168

9 Operation at Use of a PC
9.3 Configuration of the Device
Parameterizing the Binary Inputs U1/U2 and U3/U2
If you want to change the parameters for the binary inputs, please proceed as follows:
✧
In the navigation window, select the Operational parameters menu, then the Process connection
submenu, and click the element Binary inputs.
Figure 9-25
✧
Change the Parameters and the Binary input indication according to Table 9-3.
✧
After the parameterization click Send.
The parameters are transmitted to the device but not enabled yet (passive set of parameters).
✧
If you do not want to make any additional settings, continue with the Activation of the device configuration
according to section Activating the Set of Parameters. If you want to change other settings, enter the
changes and then enable the device configuration as described in section Activating the Set of
Parameters.
168
Configure Tab, Binary Inputs Input/Output Window
SICAM Q100, 7KG95xx, Device Manual
E50417-H1040-C522-A6, Edition 06.2019