Siemens SICAM Q100 7KG95 Series Manual page 185

✧
In the navigation window of the Energy management menu click Load profile.
Figure 9-40
NOTE
Changing the number and length of the subperiods deletes the load-profile buffer.
NOTE
If a binary input is used as synchronization source its properties must be configured (see chapter 9.3.3.1.2 Con-
figure -> Operational parameters -> Process connections -> Binary inputs).
✧
Select the respective parameters in the list boxes according to Table 9-10.
✧ After the parameterization click Send.
The parameters are transmitted to the device but not enabled yet (passive set of parameters).
✧ If you do not want to make any additional settings, continue with the Activation of the device configuration
according to section Activating the Set of Parameters. If you want to change other settings, enter the
changes and then enable the device configuration as described in section Activating the Set of
Parameters.
SICAM Q100, 7KG95xx, Device Manual
E50417-H1040-C522-A6, Edition 06.2019
Configure Tab, Load Profile Input/Output Window
9 Operation at Use of a PC
9.3 Configuration of the Device
185