Siemens SICAM Q100 7KG95 Series Manual page 316

9 Operation at Use of a PC
9.5 Maintenance
The following table shows examples of events logged in the audit log.
Table 9-50
Modification of security-relevant
parameterization
Firmware update
Logon succeeded
Logon failed
Value forcing
Configuration access
Configuration change
Audit log access
Time/date change
Device reboot
SD card plugged
SD card unplugged
Default IP set
316
Audit-Log Events in SICAM Q100
Event Type Description
Modify following settings:
• IP address
• Modbus TCP access rights for port 502
• Modbus TCP access rights for user port
• Modbus RTU access rights
• Device name
Upload new firmware to the device
The correct user name and password are entered.
Incorrect user name and password have been entered for the
times configured by the maximum consecutive attempts in the
chapter 6.3.2.
Delete or reset the following data:
• Operational log, error log, and transient log
• Min/max values
• Load profile
• Energy counters
• Events like voltage event, frequency event, voltage-
unbalance event, MSV event, RVC event
Upload a configuration file or start configuration
Change the configuration
Access the audit log
Change the time or the date
Device is rebooted due to:
• Firmware upload
• SD-card formatting
• IP-address change
• Default-gateway change
• Subnet-mask change
• Default IP setting change
• User-language change
• Network-type change
• IED-name change
• IEC 61850 enable
• Power-quality values for PN and PP setting change
• Voltage RMS value PN and PP setting change
Plug in an SD card
Unplug the SD card
Request the default IP address by pressing key F4 on the
device display for 5 s
SICAM Q100, 7KG95xx, Device Manual
E50417-H1040-C522-A6, Edition 06.2019