Dodge Sprinter 2006 Manual page 2024

23 - 86 STA TIONARY GLASS
Fig. 3 WINDSHIELD SEAL
1 - WINDSHIELD SEAL
2 - TRIM STICK #4755
CAUTION: Fabricate a protection guard from 2 mm
sheet plastic or equivalent to protect rubber instru-
ment panel from damage.
(5) P la ce pr ot ect ion gu a r d bet ween win dsh ield a n d
in st r u m en t pa n el sea l. (F ig. 4)
Fig. 4 INSTRUMENT PANEL SEAL
1 - WINDSHIELD
2 - SEAL PROTECTOR
3 - INSTRUMENT PANEL
4 - INSTRUMENT PANEL SEAL
(6) Usin g a win dsh ield cu t -ou t wir e sepa r a t e t h e
a dh esive. (F ig. 5)
Fig. 5 ADHESIVE SEPARATION
1 - T-HANDLE
2 - WINDSHIELD ADHESIVE
3 - COUNTER SUPPORT
4 - CUTTING WIRE
(7) Ca r efu lly r em ove win dsh ield.
INSTALLA TION
WARNING: Allow the urethane at least 24 hours to
cure before returning the vehicle to use.
CAUTION: Roll down the left and right front door
glass and open the rear glass slider (if available)
before installing windshield to avoid pressurizing
the passenger compartment if a door is slammed
before urethane is cured. Water leaks can result.
Th e win dsh ield fen ce sh ou ld be clea n ed of m ost of
it s old u r et h a n e bon din g m a t er ia l. A sm a ll a m ou n t of
old u r et h a n e, a ppr oxim a t ely 1 m m in h eigh t , sh ou ld
r em a in on t h e fen ce. Do n ot gr in d off or com plet ely
r em ove a ll old u r et h a n e fr om t h e fen ce, t h e pa in t fin -
ish a n d bon din g st r en gt h will be a dver sely a ffect ed.
Windshield Preparation - Installing A Previously
Installed Windshield
(1) Level old bea d of win dsh ield a dh esive t o a
t h ickn ess of a ppr oxim a t ely 1 m m (0.04 in .) a n d
r em ove loose a dh esive. (F ig. 6)
VA